Sign up in 30 seconds and meet someone

Hook up amp and subs in car

Published: 14.01.2017

If you really want the best response possible, your subwoofer manual will list the ideal enclosure volume for each type of enclosure. You will need to run the 16 - 18 gauge wire through the back of the center console too.

Hooking up a subwoofer and amplifier to a car stereo can add an extra dimension to your music. Subwoofers produce low frequency sounds that regular car speakers.

All it takes is a little know-how and a few tools and supplies. The other side the side you just cut is stripped and connected to the other side of the fuse holder. Insert the fuse into the power cable and put the negative cable back on the battery. How To Build A Car Amplifier This guide on how to build a car amplifier will help you with a complete installation using your hands and available pow ….

It does not really involve highly techni ….

I chose a hole that was behind my glove box and was fairly easy to get to from the engine compartment. For more information read this post on how to set up a subwoofer. Clipping is the number one reason of bass distortion. There is usually enough room on the side of the rear car seat to snake the wires from the trunk to the passenger compartment.

After you have the stereo out, look at the back of it. Run the majority of the power cable through the hole in the firewall, making sure to leave enough wire to get to the battery.

HOW TO: Install Subwoofer w/ Factory Radio

Not Helpful 5 Helpful Turn the gain all the way down, start playing music and turn it up to where you usually listen, where the mids sound good. This is the metal wall under the hood of the car, closest to the windshield. A bridged amp runs at a different impedance than the same amp in unabridged mode. Cut 15 inches off the end of the power cable. Although every car is different, there is usually a bolt connected to the metal floor under the carpet.

    1. Zloy_Admin - 19.01.2017 in 04:38

      How do I hook up a subwoofer and amp in my car? Subwoofers produce low frequency sounds that regular car speakers cannot create.

      Timur_Ussr - 26.01.2017 in 21:20

      Cabling and Wiring Connection. Once it's secure, cut a length of the power wire to reach the fuse, and connect it to one side of the fuse holder.

      Vadim_Dion - 04.02.2017 in 16:07

      Remove the door seal cables from the opposite side of the vehicle and run the signal cables and the turn on lead from the receiver to the amplifier. Electrical tape at the entry point will give the wire added protection.

      Alecksey_Chmel - 09.02.2017 in 03:31

      Installing Subwoofers in a Car by bmlbytes in audio.

      Bruno_Waster - 09.02.2017 in 20:22

      Tighten the bolt after installing the wire. Attach one length of wire from the terminal cup on the inside of the subwoofer box to the terminals of the subwoofer.

    Add review

    Your e-mail will not be published. Required fields are marked *


    Privacy Policy - Terms of Use Contact Us
    Copyright © 2008-2017 chavaipa.com All rights reserved.