Sign up in 30 seconds and meet someone

How many subs can you hook up to a monoblock amp

Published: 28.12.2017

I have never had a 2 channel and I was also wondering how well it will sound. I was just trying to figure out how to run the wires so that on every box like that i don't have to drill a hole in the box.

Hello I have 2 watt 12 inch subwoofers being pushed by a watt planet audio 1 channel amp it's distorting and keep cutting off and smoking amp runs extremely hot.

Dec 27, 2011 · Recently i hooked up a friends amp that was a mono block with 2 inputs for speaker wires (2 + and 2-) he had 2 4 ohm DVC subs.I followed the 12 volt subwoofer wiring diagram that said to hook the 2 subs up together in parallel to get a .

How to Convert a Cassette Tape to a CD Around The Home. The right type of amp to use This is a great place to use a 2-channel amp. An online search ought to bring up at least one car stereo dealership somewhere near you. Read others' stories Send Bill your story.

Answer this question Flag as

Seriously into audio since SM. How can I connect 2 8ohm speakers so they remain 8ohm? When you wire the subs as shown in the diagram below, the total impedance will be four ohms. Can't find your exact vehicle?

How To: Wire Mono Blocks & Subs - DVC/SVC - Parallel/Series

The fuse amperage should match the gauge size. Would I be able to change the settings on the amp to where only bass comes out of the subs. Don't forget to test your rem wire before you assume it works. Tony, Position your sub in your vehicle where it sounds best to you.

    1. Artem_Kliter - 07.01.2018 in 19:54

      I showed you a link in one of my answers that shows how two SVC 4-ohm subs get wired as a 2-ohm load. Can I connect the line out converter of my car stereo to the sub instead of taking apart my dash unit?

      Max_Burmatov - 10.01.2018 in 03:32

      Wiring two 4-ohm voice coils to the two terminals of a mono amp is the same as wiring them in parallel, resulting in a 2-ohm load. Michael, Two of those DVC 4-ohm model subs, wired like this , will work with that amp, but a better match would be the Rockford Fosgate TbdCP amplifier.

      Vanya_Poluh - 17.01.2018 in 16:14

      A great way to power a complete system would be to get a 5-channel amp, like a Pioneer GM-D , to take care of your four speakers and two subs.

      Matthew_Dickerson - 22.01.2018 in 19:58

      These examples are just the starting point. I actually ended up going with the amp you suggested but with Rockford p1s's 2ohm.

      Santiago_Cross - 30.01.2018 in 02:46

      Would I be able to change the settings on the amp to where only bass comes out of the subs.

    Add review

    Your e-mail will not be published. Required fields are marked *

    Privacy Policy - Terms of Use Contact Us
    Copyright © 2009-2017 All rights reserved.